• Tower Project

    On June 3rd, 2016, we installed a 92 foot Rohn 55G tower for our club repeaters. In the days leading up to this, we had assembled the pieces together on the ground and then rented a crane to raise it. Once the antennas were installed, the tower was 112 feet above ground. The job included the assembly by Paul (W5QO), Paul (K5GLH) and Larry (KD5MAF).

    In the photo above, you can see the tower lying on its side. The crane was attached and beginning to raise. To the right are both W5QO and KD5MAF.

    This photo below shows it finally upright but not fully installed. To the left is the 70-foot tower that was installed in 1980.

    Below shows the tower installed upright without the 443.300 MHz repeater installed.

    This image shows K5GLH installing the guy wires while the crane held the tower in place. He was also removing the crane’s connection to the tower..

    Below is an image of the two repeater antennas being installed. The 146.700 MHz repeater antenna is on the top and the 443.300 MHz repeater is on the side standoff.

    Below, you can see the completed tower with the antennas installed.

    This was quite an expensive and laborious job. Now that we are all getting old, we look at these pictures and cringe at the idea of doing this again. We now have two AREDN nodes on this tower but not installed in these photos.

    Leave a Reply

  • Oklahoma ARES VoIP net starting now on 146.7 MHz

    Oklahoma ARES VoIP net starting now on 146.7 MHz repeater. The offset is minus -600 with a PL tone is 103.5.

    Leave a Reply